Table of Contents
Advertisement
•
the Windows operating system fails to announce that it has Found New Hardware
Then you must manually configure the COM port. After you do this, you should orient the interactive
whiteboard to ensure accurate tracking of your finger or a pen tray tool. If the projected image
becomes misaligned, you must perform the orientation procedure again.
To select a COM port for the interactive whiteboard
1. Select Start > Programs > SMART Board Software > SMART Board Tools.
2. Click the SMART Board icon in the system tray and select Control Panel.
The SMART Board Control Panel appears.
3. On the Boards tab, click the Connect button.
The Select COM Port dialog box appears.
4. If you know the COM port to which the SMART Board interactive whiteboard is connected, you
can type it or select it from the COM port list. Then click the Select button.
OR
If you're unsure of the correct COM port, click the Detect SMART Hardware button to initiate
hardware detection. SMART board software searches your COM ports for the presence of an
attached interactive whiteboard.
The interactive whiteboard is now touch sensitive. You can write over any projected application
with a pen tray stylus.
To orient the interactive whiteboard
Click the SMART Board icon and select Orient, and then follow the on-screen instructions. You can
also access this feature by clicking the Orient button on the Boards tab of the SMART Board Control
Panel.
To change the orientation precision
1. Click the SMART Board icon and select Control Panel.
The SMART Board Control Panel appears.
2. On the Boards tab, click the Advanced button.
For Mac OS X computers, the Edit Advanced Settings dialog box appears.
For Mac OS 9.x computers or earlier, the Pick the Orientation Precision dialog box appears after
you click the Orient button. Proceed to step 4.
For Windows operating systems, select Board Settings from the shortcut menu that appears.
The Edit Advanced Board Settings dialog box appears.
3. Click the Pick the Orientation Precision tab.
4. Select the Orientation level you prefer.
5. Click the Apply button, and then OK (or Next for Mac OS 9.x computers or earlier).
6. Click the Orient button.
7. Follow the on-screen instructions. Press on each cross that appears with your finger or stylus at a
90° angle to the screen.
IMPORTANT: Keep your finger straight as it approaches the screen. Press it firmly on each
cross, and keep it straight as you pull it away from the screen.
22
2000i-DVS Installation Guide
Advertisement
Table of Contents
