Table of Contents
Advertisement
LED On (Cont'd)
Off
Off
Volume Control Buttons
+
Press the Volume Up (
the volume. The 2000i retains your settings for each source.
The default volume is 0. To restore this default, press the
Source Buttons
You can use the source buttons to switch the video and audio sources for the projector and cabinet
audio amplifier. Please note that switching sources takes a few seconds, and all buttons on the
Control Panel are disabled during that time.
Button
Source
VCR/DVD player
Internal computer
Notebook software. The internal computer source must be active. For information on
using Notebook software, see page 33.
Press this button and hold it down for three seconds to open the Floating Tools. For
information on using the Floating Tools, see page 34.
Guest laptop
NOTE: You can only switch to a connected guest laptop if your system includes the
optional X-Port 20 switch option.
LED Off
(Cont'd)
Flashing very
quickly
Flashing slowly
) button to increase the volume and the Volume Down (
2000i-DVS Installation Guide
Lamp Status (Cont'd)
Lamp is in three-minute reversible standby mode.
In this mode, the screen appears black, even
though the projector lamp remains on, allowing you
to quickly restore the display by pressing any
button on the Control Panel. After three minutes,
the lamp cools down for 60 seconds before
powering off.
Lamp is cooling down. This 60-second cool-down
follows the three-minute reversible standby period.
During this time, all Control Panel buttons are
disabled.
+
–
and
buttons simultaneously.
–
) button to decrease
7
Advertisement
Table of Contents
