To change the image size
1. Crouch behind the projector and look at the projected image through the view port.
Image Size Adjustment
2. Using the security key (TR20 Torx® tamper-recess key) from the accessory kit, loosen the three
Torx M4 security screws that secure the projector to the projector plate.
NOTE: You'll find these screws on the top of the projector plate, one at the front of the projector
and two at the back.
To access the single screw at the front of the projector, you must reach through the view port to
the front of the projector, and maneuver the security key through the center access hole in the
projector cover (see the following figure).
16
Position for Changing the Image Size
3x
Loosen the Three Hex Screws to Change Image Size
2000i-DVS Installation Guide