Table of Contents
Advertisement
To move the image vertically
1. Move to the front of the unit and crouch down, facing the screen.
Move Image Up or Down
2. Look underneath the pen tray and locate the Electronics Tray. Locate a large access hole
covered with a plastic cap on the right side of the Electronics Tray.
3. Remove the plastic cap that covers the access hole. If the cap seems tight, carefully pry it off with
a screwdriver, inserting the screwdriver into the small opening at the top of the cap.
4. Loosen and tighten the bolt inside the access hole with the supplied 7/16" nut driver to adjust the
image vertically.
5. Replace the plastic cap you removed in step 3.
18
Position for Moving the Image Up or Down
Electronics Tray
Loosening the Bolt to Move the Image Up or Down
2000i-DVS Installation Guide
Advertisement
Table of Contents
