Installing Your 2000I; Setting Up The 2000I - SMART 2000i-DVS Installation Manual

Installing Your 2000i

This section of the manual describes how to:
•
set up the 2000i (page 8)
•
install and connect the host computer (page 10)
•
adjust the projected image (page 13)
•
connect the videoconferencing/laptop shelf (page 19)
•
install SMART Board software (page 21)
•
connect a guest laptop (page 23)
•
connect a VCR or DVD player (page 24)
•
connect an external sound system (page 25)
•
connect an external projector or monitor (page 26)

Setting Up the 2000i

1. Remove the unit from its shipping carton. (To do this, follow the Unpacking Instructions.)
2. Unpack the remaining contents of the shipping carton and wheel the unit to a location that's
within reach of a power source.
NOTE: Leave enough space around the unit to comfortably perform the following assembly and
connection procedures.
3. Lock the casters by pressing down on the caster-lock tab; unlock the casters by pressing up on
this tab, as shown in the figure below.
4. Extend all four of the anti-tip feet. You'll see two holes on the outer side of each leg. To extend
the feet, depress the locking ball in the inner hole, and then pull the leg out until the locking ball
engages in the outer hole.
8
A Locked and Unlocked Caster
Locking Ball in the
inner hole
Extending an Anti-Tip Foot
2000i-DVS Installation Guide
Locking Ball in the
outer hole