Control Devices - ESAB Powercut 900 Instruction Manual

GB
5.2

Control devices

1 Power switch ON/OFF
2 Output current control
3 Display
Power switch - (1)
Turn the knob clockwise to "ON" position for normal operation. Turn the knob
counterclockwise to switch "OFF".
Output current control - (2)
Adjustable from 20 to 60 A. For settings see cut data charts in the torch manual.
Display - (3)
Shows current settings during normal operation. When the unit is initially switched
on, the software version will be briefly displayed.
When the unit is in the "GAS TEST" mode, the display will indicate the air pressure
setting in bar. The setting can be switched to psi by service technicians.
Should a fault condition exist in the normal operation, the display will show a code
number, see chapter 7.1.
bp17ea
4 Torch trigger/ Gas test trigger
5 Pressure regulator
- 13 -