Advertisement
Replacing the Top to the Battery Box
Back
To close the front panel on the battery box:
Lift the front panel
into place.
Knockout Panel
(one on each side)
Replacing the Top to the Battery Box
Installation
Sides with
folded down
edges
Front
38
1. Place the top to the battery box on
the enclosure, back edge first so
that the back edge of the enclosure
is inserted into the folded down
edges of the sides of the top.
There is a label on the underside of
the top to indicate front from back.
2. Align the screw holes from the
top to the enclosure.
3. Use the 6 6x32 Phillips
screws in the plastic bag
provided to secure the top in
place.
Torque to 1.3 nm (11.5 in-lb).
4. Remove the knockout panel on
the side of the front panel on the
battery box to accommodate the
battery connections to the inverter.
Repeat this procedure for the
second battery box if used.
Gently push the lip on
the front panel under
the lip on the top of the
battery box enclosure.
Advertisement
