Advertisement
Preparing the Battery Bank
1. Insert the batteries into the
compartment.
2. Connect the batteries as
shown below depending on the
battery configuration used.
3. Tighten the Hex nut on the
battery terminal to the battery
manufacturer's torque
requirement.
If using one battery......
*These cables are connected
to the Anderson Plugs in the
front panel of the battery box.
CONNECT SECOND:
Positive (+) (red) Cable from
the Battery Box to the Inverter*
DISCONNECT FIRST:
Positive (+) (red) Cable from
the Battery Box to the Inverter*
Important:
When disconnecting
batteries, ensure all incoming power
has been disconnected.
Then remove the Positive (+) (red)
cable FIRST , and the negative (–)
(black) cable LAST.
Preparing the Battery Bank
Installation
CONNECT FIRST:
Negative (–) (black) Cable from
the Battery Box to the Inverter*
DISCONNECT LAST:
Negative (–) (black) Cable from
the Battery Box to the Inverter*
Cable Connection Order:
35
Hex Nut
Split Washer
Cable from Battery Box
Battery Terminal
Advertisement
