(1)
Push in a new oil seal parallel to the mount-
ing hole section of the developer frame.
* Pay attention to the direction in which the
oil seal is attached. (See figure on right.)
(2)
Apply an even coat of grease to the inside of
the oil seal.
•
Amount: Less than the size of half a rice
grain
(3)
Wipe off any grease exuded from the inside.
* H7: Auto-toner sensor
Clean the surface of the auto-toner sensor with a cotton swab or soft cloth with sufficient alcohol
filled in.
5.5.9
Waste Toner Box
Items to check
I1
Waste toner box full detection
sensor
© 2008 TOSHIBA TEC CORPORATION All rights reserved
I1
Waste toner box
Fig. 5-21
Lubri-
cation/
Cleaning
Coat-
ing
B
5 - 21
Developer frame
Grease
Inside
Fig. 5-20
Replacement
(x 1,000
(x 1,000 drive
sheets)
counts)
e-STUDIO2820C/2830C/3520C/3530C/4520C
PREVENTIVE MAINTENANCE (PM)
Outside
Oil seal
Opera-
Parts
tion
list
check
<P-I>
42-104
5