Toshiba e-STUDIO2820C Service Handbook page 151

[D] Secondary scanning data laser writing start position
Performing the code 05-408 covers this adjustment for all paper sources.
The adjustment for each paper source is also available.
For all paper sources
Code Paper size
408 A3/LD
For each paper source
Order for
Paper source
adjustment
1 1st drawer
2 2nd drawer
3 PFP upper drawer
4 PFP lower drawer
5 Bypass feed
6 Duplexing
While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
(2) Press [98] ([3] for duplexing) → [FAX]. (A grid pattern with 10 mm squares is printed out.)
(3) Measure the distance D from the leading edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance D is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
<Procedure>
(Adjustment Mode) → (Key in the code shown above) → [START]
→ (Key in an acceptable value shown above)
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed
→ Press [98] ([3] for duplexing)
→ [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.10 mm/
step).
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Acceptable value
0 to 200 Performs the adjustment for all paper sources.
Code Paper size
440 A4/LT
441 A3/LD
444 A4/LT
428 A4/LT
442 A4/LT
445 A3/LD
3 - 19
Remarks
Acceptable
Remarks
value
0 to 100
0 to 100
0 to 100
0 to 100
0 to 100
0 to 100 Paper fed from the 2nd drawer
e-STUDIO2820C/2830C/3520C/3530C/4520C
3
ADJUSTMENT