Removing A 3.5-Inch Device - HP ProDesk 600 G1 Maintenance And Service Manual

7. Connect the opposite end of the data cable to one of the light blue SATA connectors on the system
board.
NOTE:
drive connectors.
8. Replace the front bezel.
NOTE:
from HP. Install the bezel trim piece in the front bezel before replacing the front bezel.

Removing a 3.5-inch device

CAUTION:
computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the drive cables from the rear of the drive, or, if you are removing a media card
reader, disconnect the USB cable from the system board as indicated in the following illustration.
56 Chapter 5 Removal and replacement procedures: Tower (TWR)
Refer to System board connections on page 50
An optional bezel trim piece that surrounds the front of the 5.25-inch drive is available
All removable media should be taken out of a drive before removing the drive from the
(Access panel on page
(Front bezel on page
for an illustration of the system board
(Preparation for disassembly on page
38)
40)
37)