Installing A Mainboard Module - QUANTA STRATOS S210 Series S210-X12RS Technical Manual

I H
NSTALLING ARDWARE
3. Lift mainboard in an angle to release the connectors from
the slots on rear panel.
Port Openings
Figure 2-18. Removing the Mainboard
4. Remove the mainboard from the chassis.
.

Installing a Mainboard Module

Prerequisite: Prerequisite:
Remove the top cover. See Opening the Top Cover on
page 2-2.
1. Place the mainboard on the chassis.
2. Align the mainboard with the port openings on the rear of
the chassis.
3. Align the mainboard opening with the chassis guide pin.
4. Install the mainboard on the chassis.
2-12
I M M
NSTALLING A AINBOARD ODULE