Lock/Security; Terminal Security Code; I-Mode Password; Pin1/Pin2 Code - Docomo Style series F-10C Instruction Manual

Lock/Security

Security codes
Security codes vary by functions. Security code
protects personal information. Be careful about
handling the security code.

Terminal security code

(Default : 0000)
The code is the security code to be used when
changing settings or deleting all the items at once.
To change the code, perform the following
operation.
a meh Settingef
c Code & Fingerprintea Change
security codeeAuthenticate
b
Enter a new terminal security
Enter the new terminal security code in
New terminal security code-check field
eC [Save]
Point
If a wrong terminal security code is entered 5 times
consecutively, the power is turned OFF.

Network security code

(At subscription : Set any code)
Network security code is required when DOCOMO
identifies the subscriber at docomo Shop,
docomo Information Center or "
(user support)" or when you subscribe Network
Services. To change the code, perform the
following operation.
38
a
i-mode password is required to save to/delete My
Lock/Securitye
Menu, use Message Service, subscribe/cancel i-
mode charged services, etc. To change the code,
perform the following operation.
codee a
You can set 2 security codes to the UIM: PIN1 code
and PIN2 code.
The PIN1 code is a security code to be used when
installing the UIM or turning ON the FOMA
terminal.
The PIN2 code is the security code to be used
when requesting the issuance of a user certificate,
resetting Total calls cost or resetting the total call
costs.
Ie
"
e
" (
(Settings (Check/Change/Use))"
"
Network security code)" (in Japanese
only)

i-mode password

(At subscription : 0000)
Ie
"
e
" (
(Settings (Check/Change/Use))"
Password)" (in Japanese only)

PIN1/PIN2 code

(At subscription : 0000)
(User support)"
)
e
(Change
(User support)"
)
e
"
(Change i-mode