Casio QT-2000 Service Manual page 66

(22) ARCNET test-1 (ID number setting)
Sets ID number of ARCNET. Be sure to perform this program before doing the following ARCNET tests.
Operation: [m][m][m][3][8][SUB TOTAL]
mmm = ID number (001 to 253)
Display: <LCD>
R/J print:
ARC-ID
END
(23) ARCNET test-2 (baud rate setting, ARCNET communication)
After setting the baud rate, QT-2000s in the ARCNET start communications.
Operation: [n][3][9][SUB TOTAL]
n = baud rate; 0: 156.25kbps, 1: 312.5kbps, 2: 625kbps, 3: 1.25Mbps
Display: <LCD>
R/J print:
ARC–BPS
END
ARC - ID 38
ARCNET MY - ID: xxx ID No. ; 1 to 253
Indicates "INVALID ID XXX"
END 38
when invalid number is in-
put.
38
38
ARC–BPS 39
OK
or "NG"
END 39
39
39
<Dot/7-segment>
0
Dot/7-segment display indicates 0 only when
the test is continued from the "Dot/7-segment
display test." When the test is performed
indipendently, the dot/7-segment display indi-
cates nothing.
<Dot/7-segment>
0
Dot/7-segment display indicates 0 only when
the test is continued from the "Dot/7-segment
display test." When the test is performed
indipendently, the dot/7-segment display indi-
cates nothing.
— 64 —
0
0