Changing The Tv Settings - Pace DC 221 User Manual

CHANGING THE TV SETTINGS

This screen allows you to specify the type of TV
you have connected to your set-top box. Making
the correct settings at this screen will ensure you
have the best picture available.
From the Service Sub-Menu (see page 34),
highlight 'TV Settings' then press OK. The TV
Settings screen displays (see right).
Use U D to highlight the item you want to change,
then use L R to select the setting.
Use the table below to help you choose the
settings you want. The factory settings (when
Item Settings
TV screen format *4:3
Letterbox
16:9
Video signal *CVBS
RGB
S-Video
AV control *on
off
SAVING YOUR CHANGES
When you have made the changes you wish to
make, press OK.
If you do not want to save your changes, press the
Zurück button.
your set-top box is new or if you reset your set-top
box as described on page 40), are shown with a
star * against them.
Comments
If you have a widescreen TV, set this to '16:9'. If you have a
standard TV, set it to '4:3' or 'Letterbox'. Note: Your choice of
setting affects widescreen transmissions. With '4:3', the centre
portion only of widescreen transmissions displays. With
'Letterbox' the whole of a widescreen transmission displays, but
the picture does not fill the screen.
If you have an RGB-compatible TV, choose the 'RGB' setting to
give a better quality picture.
If you have an S-Video TV, choose 'S-Video'.
If neither of the above apply, choose 'CVBS'.
Note: Unless your VCR is S-Video-compatible, do not choose 'S-
Video', as that will result in black and white recordings.
If this is set 'On', your TV should switch automatically to show
digital channels from your set-top box on the TV screen,
whenever your set-top box is on. You may prefer to use your TV's
remote control to select the appropriate AV channel on your TV
(in which case, set 'Off').
SERVICE SUB-MENU
Kabel Digital
. 35