Flavel Finesse FSRC**MN Installation, Maintenance & User Instructions page 14

IMPORTANT : Sealing of the Gas Inlet Apertures
In line with current CORGI regulations, it is imperative that the gas supply inlet
aperture that is utilised during the installation is sealed with the grommet
as supplied in the loose items pack. The product is manufactured with 3 knock
out gas inlets in the firebox wrap to allow a left hand, right hand or rear gas inlet
supply to the inlet elbow. Using a hammer and a blunt chisel, remove the inlet
aperture selected and then seal with the grommet supplied. To provide access for
the gas supply pipe, cut the grommet with a sharp knife. Failure to seal the inlet
apertures could lead to flame reversal, which in turn will damage the burner and
control systems of the product.
Fig. 6 below shows a correctly sealed installation.
Fig. 6
PLEASE NOTE :-
BFM EUROPE LTD. WILL NOT BE LIABLE FOR
GUARANTEE CLAIMS THAT ARE AS A DIRECT
RESULT OF THE GAS INLET APERTURE NOT BEING
CORRECTLY SEALED WITH THE GROMMET
PROVIDED.
Grommet fitted and cut to
provide access for the gas
supply pipe.
14