Table of Contents
Advertisement
S
S
UPER
ERVER 6015C-M3/6015C-MT User's Manual
2-5
Checking the Serverboard Setup
After you install the 6015C-M3/6015C-MT in the rack, you will need to open the
unit to make sure the serverboard is properly installed and all the connections
have been made.
Accessing the inside of the System
1.
First, release the retention screws that secure the unit to the rack.Grasp the
two handles on either side and pull the unit straight out until it locks (you will
hear a "click").
2.
Depress the two buttons on the top of the chassis to release the top cover.
There is a large rectangular recess in the middle front of the top cover to help
you push the cover away from you until it stops.
3.
Lift the top cover from the chassis to gain full access to the inside of the
server.
Checking the Components and Setup
1.
You may have one or more processors already installed into the system
board. Each processor should have its own heatsink attached. See Chapter 5
for instructions on processor installation.
2.
Your 6015C-M3/6015C-MT server system may have come with system
memory already installed. Make sure all DIMMs are fully seated in their slots.
For details on adding system memory, refer to Chapter 5.
3.
If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
4.
Make sure all power and data cables are properly connected and not blocking
the airfl ow. Also make sure that no cables are positioned in front of the fans.
See Chapter 5 for details on cable connections.
2-8
Advertisement
Table of Contents
