Table of Contents
Advertisement
1-3
Server Chassis Features
The following is a general outline of the main features of the SC813MTQ-520C
chassis. Details on the chassis can be found in Chapter 6.
System Power
When confi gured as a SuperServer 6015C-M3/6015C-MT, the SC813MTQ-520C
chassis includes a single 520W power supply.
SAS/SATA Subsystem
For the 6015C-M3, the SC813MTQ-520C chassis was designed to support
four SAS hard drives, which are hot-swappable units. For the 6015C-MT, the
SC813MTQ-520C chassis was designed to support four SATA hard drives, which
are also hot-swappable units. Note: The operating system you use must have
RAID support to enable the hot-swap capability of the SAS/SATA drives.
Control Panel
The SC813MTQ-520C's control panel provides important system monitoring and
control information. LEDs indicate power on, network activity, hard disk drive activ-
ity and system overheat conditions. The control panel also includes a main power
button and a system reset button. The front of the SC813MTQ-520C also includes
a COM port and two USB serial ports for easy access.
Rear I/O Panel
The SC813MTQ-520C is a 1U rackmount chassis. Its I/O panel provides a slot for
one full-height, half-length PCI expansion card, one COM port (another is internal),
two USB ports, a VGA port, PS/2 mouse and keyboard ports and two Gb Ethernet
ports. See Chapter 6 for details.
Cooling System
The SC813MTQ-520C chassis has an innovative cooling design that features four
high-performance 4-cm fans. Each of these fans plug into a chassis fan header
on the serverboard. An air shroud channels the airfl ow generated by the fans to
effi ciently cool the processor area of the system.
A fan speed control setting in BIOS allows fan speed to be determined by system
temperature [the recommended setting is 3-pin (Server)].
Chapter 1: Introduction
1-5
Advertisement
Table of Contents
