Overheat Led (Oh); Nic2 (Lan2) Led; Nic1 (Lan1) Led; Hdd Led - Supero SUPERSERVER 6015C-M3 User Manual

Table of Contents

Advertisement

Overheat LED (OH)

Connect an LED to the OH connection
on pins 7 and 8 of JF1 to provide ad-
vanced warning of chassis overheat-
ing. Refer to the table on the right for
pin defi nitions.

NIC2 (LAN2) LED

The LED connections for LAN2 are
on pins 9 and 10 of JF1. Attach LAN
LED cables to display network activ-
ity. See the table on the right for pin
defi nitions.

NIC1 (LAN1) LED

The LED connections for LAN1 are
on pins 11 and 12 of JF1. Attach LAN
LED cables to display network activ-
ity. See the table on the right for pin
defi nitions.

HDD LED

The HDD LED connection is located
on pins 13 and 14 of JF1. Attach the
hard drive LED cable here to display
disk activity (for any hard drives on the
system, including SAS, Serial ATA and
IDE). See the table on the right for pin
defi nitions

Power On LED

The Power On LED connector is lo-
cated on pins 15 and 16 of JF1. This
connection is used to provide LED
indication of power being supplied to
the system. See the table on the right
for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
OH/Fan Fail LED
Pin Defi nitions (JF1)
Pin#
7
8
Pin Defi nitions (JF1)
Pin#
9
10
Pin Defi nitions (JF1)
Pin#
11
12
Pin Defi nitions (JF1)
Pin#
13
14
Power LED
Pin Defi nitions (JF1)
Pin#
15
16
5-13
Defi nition
Vcc
Ground
NIC2 LED
Defi nition
Vcc
Ground
NIC1 LED
Defi nition
Vcc
Ground
HDD LED
Defi nition
Vcc
HD Active
Defi nition
5V Stby
Control

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superserver 6015c-mt

Table of Contents