Cpu_Vrm Overheat Led Indicators (Led5/Led6); 5-12 Floppy And Ide Drive Connections; Floppy Connector - Supero SUPERSERVER 6015C-M3 User Manual

CPU_VRM Overheat LED Indicators
(LED5/LED6)
The two CPU_VRM Overheat LEDs
designated LE5/LE6 provide indication
for CPU1 and CPU2 VRM overheat, re-
spectively. Refer to the table on the right
for LED5 and LED6 indications.

5-12 Floppy and IDE Drive Connections

Use the following information to connect the IDE hard disk drive cables.
•
A red mark on a wire typically designates the location of pin 1.
•
The 80-wire ATA100/66 IDE hard disk drive cable that came with your system
has two connectors to support two drives. This special cable should be used
to take advantage of the speed this new technology offers. The blue connector
connects to the onboard IDE connector interface and the other connector(s) to
your hard drive(s). Consult the documentation that came with your disk drive for
details on actual jumper locations and settings for the hard disk drive.

Floppy Connector

The fl oppy connector is located
by the IDE slot. See the table at
right for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
CPU_VRM Overheat LED Indicators
(LED5/LED6)
LED# Description
LED: On CPU1_VRM Overheat
LED6: On CPU2_VRM Overheat
Floppy Drive Connector
Pin Defi nitions (Floppy)
Pin# Defi nition Pin #
1 Ground
3 Ground
5 Key
7 Ground
9 Ground
11 Ground
13 Ground
15 Ground
17 Ground
19 Ground
21 Ground
23 Ground
25 Ground
27 Ground
29 Ground
31 Ground
33 Ground
5-21
Defi nition
2 FDHDIN
4 Reserved
6 FDEDIN
8 Index
10 Motor Enable
12 Drive Select B
14 Drive Select B
16 Motor Enable
18 DIR
20 STEP
22 Write Data
24 Write Gate
26 Track 00
28 Write Protect
30 Read Data
32 Side 1 Select
34 Diskette