Table of Contents
Advertisement
1.5.3
Ethernet Configuration
The MIC-3393 is equipped with two high performances, PCI-Express based, network
interface controllers which provide fully compliant IEEE802.3 10/100/1000 Mbps
Ethernet interfaces; also one ICH9R built-in PHY chip which also provides 10/100/
1000 Mbps Ethernet interface. Users can choose the LAN1 and LAN2 either via the
front panel RJ-45 connectors or the LAN1, LAN2 and LAN3 on the rear I/O module.
Furthermore, the MIC-3393 supports the PICMG 2.16 Packet Switching Backplane
Specification via the J3 connector.
1.5.4
SATA Daughter Board Connector (CNSATA1 and Extension
Module)
The MIC-3393 provides one SATA interface via CNSATA1 connector for either a
daughter for SATA HDD, or a SATA-to-IDE daughter board for CompactFlash. Each
one of them is optional as onboard HDD is occupied the same space of Compact-
Flash. Two SATA interfaces are connected to XTM for extra SATA HDDs request.
MIC-3312-A2E provides two SATA HDD sockets for users who require on-board CF
card and also additional SATA HDDs on the extension module.
1.5.5
System Rest and BMC Reset Button
The MIC-3393 provides a system reset button located on the front panel. The system
reset button resets all payload and application-related circuitry. It does not rest the
system management (IPMI) related circuitry. A separate BMC reset button on the
front panel is provided for the BMC and related hardware.
1.5.6
VGA Display Connector (Rear I/O)
Both RIO-3311-A1E or the RIO-3311-A2E RTM module incorporates the XGI Volari
Z11 GPU, which integrates a PCI-Express 1x controller and a 64-bit 2D graphics
engine. It offers a flexible 16-bit DDR-II memory interface. The Z11 can achieve high
2D performance with a memory interface supporting a bandwidth of up to 1 GB/s
(DDR-II @250MHz). The maximum resolution is 1600 x 1200 at 70 Hz.
1.5.7
Mini-SAS Connector (Rear I/O)
The RIO-3311-A1E provides one SAS interface integrates with a 3.0 Gbit/s SAS/
SATA controller that is compliant with the Fusion-MPT (Message Passing Technol-
ogy) architecture, provides an eight-lane PCI Express interface, and supports inte-
grated RAID technology. The controller is routed to a x4 mini-SAS connector on the
front panel for a mini-SAS (SFF8088) cable when connecting externally; or to four
on-board SATA Gen. 2 ports by adjusting SW1 switch setting. Figure 1.6, 1.7 and 1.8
describe SAS configurations.
–
Blades, RTMs and drives must be
installed in a same chassis
–
Two drives shared by two blades
when executing RAID 1
–
Use 2pcs 1:2 cable (1x SFF8482,
2x SATA & 1x Power) for internal
connectors
Figure 1.6 SAS Configuration Scenario 1 - Shared Drives
15
MIC-3393 User Manual
Advertisement
Table of Contents
