Table of Contents
Advertisement
2.16.4 TTL LCD/DSTN connector(CN17)
CN17 is a 40-pin connector for TTL LCD or DSTN. It could connect
TTL LCD or DSTN freely to meet your need.
2.17 USB connectors (CN4,CN11,CN12)
The POD-6552 board provides up to six USB (Universal Serial Bus)
ports. This gives complete Plug and Play, and hot attach/detach for up to
127 external devices. The USB interfaces comply with USB specification
Rev. 2.0, and are fuse protected.
The USB interface is accessed through the 5 x 2-pin flat-cable connector,
CN4(USB0, 1),CN12(USB2, 3),CN11(USB4,5). You will need an
adapter cable if you use a standard USB connector. The adapter cable has
a 5 x 2-pin connector on one end and a USB connector on the other.
The USB interfaces can be disabled in the system BIOS setup.
2.18 Ethernet configuration
The POD-6552 is equipped with a high performance 32-bit PCI-bus Eth-
ernet interface which is fully compliant with IEEE 802.3U 10/100Mbps
CSMA/CD standards. It is supported by all major network operating sys-
tems.
The POD-6552 supports 10/100Base-T Ethernet connections with
onboard RJ-45 connectors(CN6).
2.18.1 LAN connector (CN6)
10/100 or 1000 Base-T connects to the POD-6552 via a cable to a stan-
dard RJ-45 connector.
2.18.2 Network boot
The Network Boot feature can be utilized by incorporating the Boot
ROM image files for the appropriate network operating system. The Boot
ROM BIOS files are included in the system BIOS, which is on the utility
CD disc.
2.19 COM port connector (CN2,CN9)
The POD-6552 provides four serial ports (COM1,COM3,COM4: RS-232
and COM2: RS232/RS422/RS485). CN2 supports COM1 and COM2;
CN9 supports COM3, COM4. and J1/J2/J3/J4 is for COM2 RS232/
RS422/RS485 selection. It provides connections for serial devices (a
Download from Www.Somanuals.com. All Manuals Search And Download.
19
Chapter 2 Installation
Advertisement
Table of Contents
