Canceling Cleaning Cycles - Polaris 9400 Sport 4WD Owner's Manual

The days of the week flash twice.
The day and time flashes indicating the setting
for current day and time.
NOTE: If the display flashes all zeros, the time has not been
set (new cleaner). Day and time must be set before
you can program cleaning times, see section 5.2
Change Day and Time.
4. Press to begin programming a new
cleaning cycle.
5. Press or
through seven (7) days and display desired
day(s).
6. Press to select.
hour setting flashes zero.
7. Press or
through 24 hours and display desired hour
setting.
8. Press to select.
Minutes setting flashes zero.
9. Press or
through four 15- minute periods (00, 15, 30, or
45) and display desired minutes setting.
10. Press to select.
buttons to cycle
buttons to cycle
buttons to cycle
The next day to program flashes.
11. Press to program a new cleaning cycle
for the selected day.
12. Repeat steps to program additional cleaning
cycles,
OR
Press to exit the programming menu.
Current day and time is displayed.
5.4

Canceling Cleaning Cycles

To Cancel a Specific Cycle:
1. Press to enter the programming menu.
2. Press or
through seven (7) days and display desired
day(s).
3. Press to delete programming for the
selected day.
The display turns off for one (1) second then
exits the programming menu. The current day
and time is displayed on the screen.
To Cancel All Programmed Cycles:
1. Press to make sure you have exited the
Programming Menu.
2. Press and hold
programming in the control unit.
The display turns off for one (1) second then
exits the programming menu. The current day
and time is displayed on the screen.
Page 13
buttons to cycle
to delete all