Polaris 9400 Sport 4WD Owner's Manual page 10

Page 10
When you connect the control box and power on the
cleaner, the operating time for the current selected
cycle is displayed. The default cleaning surface setting
for the 9400 4WD / P94 4WD is Bottom Surface
. To change the current programmed cycle, see
Section 5. Programming the Cleaner.
Select Cleaning Surface:
Use to change cleaning surface setting.
Toggle between:
Display Current
Time/ Set Time
Program Cleaning
Cycles / Set Time
Select Cleaning Surface
• Bottom
• Bottom and Sides
Figure 16. 9400 4WD / P94 4WD Control Unit Functions
BOTTOM ONLY
BOTTOM AND SIDES
Begin Cleaning:
NOTE: The 9400 cleans so efficiently that it is only
necessary to run three cleaning cycles per week.
After selecting the cleaning surface, press
operation.
The screen displays the time remaining for the selected
cycle. For example, 0:44 on the display indicates that
cleaning will be completed in 44 minutes.
NOTE: The control unit automatically switches to standby
power mode after 10 minutes of inactivity and
the display screen turns off. Press any key to exit
standby mode. Cleaner will continue to function in
standby mode if in the middle of a cleaning cycle.
to begin
Navigate Day/hour
Validate Time Setting
Selection
Cancel Programming
Remove Cleaner
from Pool
Start/Stop Cleaner
Operation