Control Unit Error Codes; Viewing Cleaner Information For Troubleshooting - Polaris 9400 Sport 4WD Owner's Manual

8.2

Control Unit Error Codes

The control unit will display one of ten different error codes to indicate specific problems with either the control unit or
mechanically with the cleaner.
• To remove an error code after troubleshooting, press any key and the control box turns off.
• If an error code is displayed and no key pressed, the screen goes into standby mode after 10 minutes of inactivity.
Press any key to turn the screen back on.
• When an error is detected, programming for the control unit is temporarily suspended. The
turned off.
Press and hold the
Error Code
1, 2,3
4
5, 6
7, 8
10
8.3

Viewing Cleaner information for Troubleshooting

Additional information about your cleaner's current status and any relevent error condition is available
through a troubleshooting status screen. To view this information:
1. Remove cleaner from the pool and turn power off.
2. Press
and at the same time and hold for at least five (5) seconds.
The following cleaner operation messages are displayed consecutively for three (3) seconds:
After cycling through each message, control unit returns to current day and time display.
button to clear the error code and reactivate current programming.
Cause
Cleaner malfunction.
Pump motor overconsumption
Drive motors overconsumption
Cleaner is turned on and running out
of water.
Cleaner communication error.
Total hours cleaner has operated since new.
Last error code (if cleaner has had at least one error).
Time (in operating hours) the error occurred.
Solution
Contact your retailer.
Check for small debris or hair in the fan. Clean the
filter.
Check for any small debris or cable stopping
brushes from turning freely. Turn the wheel to the
left, then right one quarter turn in both directions.
Turn cleaner power off, then submerge cleaner
according to correct procedure.
Turn cleaner power off then back on to restart the
program.
Page 19
button is