. GENERAL INFORMATION
After routing, check that the wire harnesses
are not twisted or kinked.
Wire harnesses routed along with
handlebar should not be pulled tight, have
excessive slack or interfere with adjacent
or surrounding parts in all steering
When a testing device is used, make sure to
understand the operating methods
thoroughly and operate according to the
Be careful not to drop any parts.
When rust is found on a terminal, remove
the rust with sand paper or equivalent
Remove the rest
The following symbols represent the
servicing methods and cautions included in
this service manual.
: Apply engine oil to the
designated engine oil for
: Apply grease for lubrication.
: Use special tool.
: Refer to page 12-3.
ZX / SCOUT