Download  Print this page

Advertisement

Table of Contents
6
. CYLINDER HEAD/CYLINDER/PISTON
The cylinder has an A mark or no mark
on it.
When replacing the cylinder
with a new one, use a cylinder having
the same mark as the old one.
Measure the piston O.D. at a point 5mm
from the bottom of the piston skirt.
Service Limit:
38.90mm replace if below
Measure the piston-to-cylinder clearance.
Service Limit:
0.10mm replace if over
Measure the piston pin hole I.D.
Service Limit:
12.03mm replace if over
Measure the piston pin O.D.
Service Limit:
11.98mm replace if below
Measure the piston-to-piston pin clearance.
Service Limit:
0.03mm replace if over
ZX / SCOUT
A Mark Nuts
6-8

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: