Listening To Audio From A Connected Component - Sony MHC-GNZ9D Operating Instructions Manual

D TV/SAT OUT L/R jacks (except
for MHC-GNZ5D)
Use audio cords (not supplied) to connect an
optional analog component (TV, VCR or MD
deck, etc.) to these jacks. You can then output
audio to the component from this system.
Note
If you press AUDIO, SOUND FIELD or the buttons
related to karaoke mode, or if you connect or
disconnect microphones or headphones, the sound cuts
off for a moment.
E SUBWOOFER OUT jack
(MHC-GNZ8D/GNZ7D only)
Use an audio cord (not supplied) to connect an
optional subwoofer* to this jack. You can then
output audio to the component from this system.
Refer to the operating instructions supplied with
the connected subwoofer.
* SA-GNV111 is recommended. In some areas, SA-
GNV111 is not available.
Note
The effects may be limited or noise may occur
depending on the connected subwoofer or the type of
music being played. For details, consult your nearest
Sony dealer.
F DIGITAL OUT OPTICAL jack
(MHC-GNZ7D/GNZ5D only)
Use a digital optical cord (square, not supplied)
to connect an amplifier with a digital optical
input jack. Sound is then output when the system
function is set to DVD. By connecting this
system to the optical input jack of the optional
amplifier equipped with Dolby Digital or DTS
decoder, you can enjoy the 5.1 channel sound. If
the jack is covered with a cap, remove it before
use.
Note
If you press AUDIO, SOUND FIELD or the buttons
related to karaoke mode, or if you connect or
disconnect microphones or headphones, the sound cuts
off for a moment.
70 GB
G COMPONENT VIDEO OUT
jacks (except for MHC-GNZ5D)
Use an optional video cord to connect a TV. If
your TV accept progressive format file signals,
you must use this connection and set the
PROGRESSIVE setting to "PROGRESSIVE
AUTO" or "PROGRESSIVE VIDEO"
(page 40).
Note
You cannot output component video using VIDEO
INPUT VIDEO jack.
H S VIDEO OUT jack (except for
MHC-GNZ5D)
Use an S video cord (not supplied) to connect an
optional TV to this jack. You can enjoy higher
quality video images.
Note
You cannot output S video using VIDEO INPUT
VIDEO jack.
Listening to audio from a
connected component
(Except for MHC-GNZ5D)
Use buttons on the unit for the operation.
1
Connect audio cords.
See "Hooking up optional components" on
page 69.
2
Press one of the following buttons to
switch the function.
• TV/SAT: To listen to audio from an
optional component connected to TV/
SAT IN L/R jacks.
The function switches to TV or SAT.
• VIDEO: To listen to audio from an
optional component connected to VIDEO
INPUT AUDIO L/R jacks.
The function switches to VIDEO.
3
Start playing the connected
component.