Baxi Solo 2 60 RS Installation And Servicing Instructions page 15

Wall mounted room sealed gas fired central heating boilers
Table of Contents

Advertisement

Installation - Page 15
Initial Preparation
Unpack the contents of carton leaving the combustion box
and mounting plate assembled on the base tray. Place the
outer case in a safe place until required. Detach the fixing
template from the packaging.
Remove the two wing nuts securing the combustion box to
the mounting plate.
Disengage the spring latch and lift the combustion box away
from the airbox. Place the combustion box on its back.
Choose a flat vertical area to position the boiler, making
necessary allowances for required minimum clearances. If
fitting between wall cupboards ensure that the minimum
available width is as shown.
Hold the wall template against the wall at the required boiler
location. Ensure that the top of the template is level. The
template represents the outer limits of the appliance, plus
the required minimum clearances.
1
NOTE: On gravity applications a clearance of 80mm (3
/
in)
8
is required from the top panel.
If fitting the appliance between or adjacent to kitchen wall
units, ensure that the line on the template indicating the
lower edge of the boiler is level with the lower edge of the
units and is correctly spaced.
If fitting the appliance in a compartment or cupboard with
suitable air vents (see Ventilation of Compartments), ensure
that the bottom edge of the template is level with the lower
edge of the units and is correctly spaced.
Two holes are provided on the template to allow gas and
electrical supplies to be brought directly into the boiler from
the wall. The grommet provided must be used when the
electrical cable is routed through the wall mounting plate.
Mark the position of the flue hole and four good anchorage
points. Where possible use the uppermost and lowest fixing
hole positions, otherwise space the fixing holes as far apart
as possible. Mark gas and electrical supply access holes if
required. Cut out hole for flue. Drill anchorage holes 7mm
9
(
/
in) diameter by 63mm (2½ in) deep to accept wall plugs.
32
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Solo 2 50 rsSolo 2 40 rsSolo 2 30 rs

Table of Contents