Infopia Glucolab Instructions For Use Manual page 8

Before You Test
Setting the Temperature Unit Setting testing averages
• After pressing and releasing • After pressing and releasing
either or buttons to set either
℃ or ℉, enter
the average of testing day,
enter
Setting the Alarm Time Setting the Alarm
• After pressing and releasing • After programing the
either or buttons to set number of desired alarms
the alarm time, enter enter
◆
User can set upto 5 daily alarms as well as designate 3 unique glucose averages
Caution
1. VERY IMPORTANT: Set the right test unit. Your GlucoLab Meter is pre-set to mg/dL
as test unit. A wrong test unit will lead to wrong test result display. Please consult
your healthcare professional if you're not sure which test unit to use. Without setting
the date properly, the average glucose level and the results in memory will not show
proper values. It is recommended to set the glucose test meter before use and also
when new batteries are installed.
2. You cannot test your blood glucose in the setting mode.
3. To turn the meter off during the setup, press for at least 3 seconds.
14
Setting the Alarm
• After pressing and releasing
or buttons to set either or buttons to set
the alarm, enter
Complete all Setting Mode
• After completing the set up,
all of the symbols are
displayed briefly before the
meter automatically shuts off.
Before You Test
Check your meter with the check strip.
The "check strip" is to make sure that your meter is functioning properly.
Note : In order to perform the more accurate glucose control solution
test, you can use the control solution 3 different levels – low, normal
and high.
You can buy each Auto-coding control solution (low, normal
and high levels) separately, please consult your local distributor about
control solutions.
Insert the check strip with the " <<< " facing up in the test strip port of your meter.
The check strip automatically checks your meter when it is inserted into the test port.
If the value displayed is between the ranges of 107 - 127, your meter is functioning
properly.
If the value displayed does not meet the proper range, the LCD will display an "Er 1"
message.
If after reinserting the check strip you receive the same error, please contact your
local representative.
It is important to check your
To ensure proper test results, please check your system periodically.
meter system after purchasing.
15