Water Supply Connection (Dw-Im Version Only); First-Time Use; Temperature Control - Vitrifrigo DW Series Installation Manual

5.6 - WATER SUPPLY cONNEcTION (DW-IM version only)

Connect the water mains to the threaded filler on the solenoid valve (A) using the special hose
(11) supplied (Fig. 5.6.1).
PLEASE NOTE:
This appliance is suitable to work with a water pressure between
1 - 3 bar (0.1 - 0.3 MPa).
WARNING
Make sure that the water mains is providing drinking water.
EN
Make sure that the water mains has the necessary pressure for ice-making cycles of between
120/135 g: optimum pressure 2 bar (0.2 MPa).
We recommend fitting a shut-off valve on the water line.
6 – FIRST-TIME USE
WARNING
Read through the whole safety section before using the appliance.
6.1 - SETTINGS:
6.1.1 -

TEMPERATURE cONTROL

The electronic "LED" thermostat has two button controls:
• An "ON/OFF" control "
• A temperature adjustment control "
Pressing the control marked "
To set the required temperature, press the control marked "
control is pressed, the LED indicator (Fig. 6.1.1.1) will light up from left to right; for intermediate
settings, two adjacent LEDs will light up.
When the LED lights up on the left, the appliance is at minimum (warmer temperature).
66
Fig. 5.6.1
  
  
  




" (Fig. 6.1.1.1)
" (Fig 6.1.1.1)
" (Fig. 6.1.1.1) will switch the refrigerator on or off, alternatively.
O
 
 

   



" (Fig. 6.1.1.1). Each time this
A
A4