Dell PowerEdge R530 Owner's Manual page 124

1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the #2 Phillips screwdriver ready.
Steps
1. Unpack the new system board assembly.
CAUTION: Do not lift the system board assembly by holding a memory module, processor, or
other components.
CAUTION: Take care not to damage the system identification button while placing the
system board into the chassis.
2. Hold the touch points and lower the system board into the chassis.
3. Push the system board toward the back of the chassis until the board clicks into place.
Next steps
1. Install the Trusted Platform Module (TPM). For more information on TPM, see
Module.
2. Install / connect the following components:
a. integrated storage controller card
b. internal USB key (if installed)
c. internal dual SD module
d. the expansion-card riser
e. heat sink(s)/heat-sink blank(s) and processors(s)/processor blank(s)
f. memory modules and memory module blanks
g. cooling-fans
h. cooling shroud
i. power supply unit(s)
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall .
4. Follow the procedure listed in
5. Ensure that you:
a. Use the Easy Restore feature to restore the service tag.
b. If the service tag is not backed up in the backup flash device, enter the system service tag
manually.
c. Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell
Remote Access Controller 8 (iDRAC8) User's Guide, at dell.com/esmmanuals.
d. Update the BIOS and iDRAC versions.
e. Re-enable the Trusted Platform Module (TPM).
Related Links
Installing the Trusted Platform Module
Installing the integrated storage controller card
Replacing the internal USB key
Installing the internal dual SD module
Installing the (optional) expansion-card riser
Installing a processor
124
Safety instructions.
Before working inside your
After working inside your
system.
Trusted Platform
system.