Installing A Cooling Fan; Internal Usb Memory Key (Optional); Replacing The Internal Usb Key - Dell PowerEdge R530 Owner's Manual

Hide thumbs Also See for PowerEdge R530:
Table of Contents

Advertisement

Installing a cooling fan

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Ensure that you read the
2.
Follow the procedure listed in
Steps
1.
Align the fan with the cable end of the fan toward the system board connector.
2.
Lower the fan into the fan bracket until it clicks into position.
3.
Connect the fan's power cable to the corresponding power connector on the system board.
4.
Route the cable through the cable holders on the fan bracket.
Next steps
Follow the procedure listed in

Internal USB memory key (optional)

An optional USB memory key installed inside your system can be used as a boot device, security key, or
mass storage device. The USB connector must be enabled by the Internal USB Port option in the
Integrated Devices screen of the System Setup.
To boot from the USB memory key, configure the USB memory key with a boot image, and then specify
the USB memory key in the boot sequence in the System Setup.
NOTE: To locate the internal USB connector (INT_USB) on the system board, see
connectors.

Replacing the internal USB key

Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
3.
If applicable, remove the PCIe expansion-card riser
4.
If applicable, remove the full length PCIe expansion card.
5.
Remove the cooling shroud.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Locate the USB connector/USB key on the system board.
Safety
instructions.
Before working inside your
After working inside your
Safety
instructions.
Before working inside your
system.
system.
system.
System board
71

Advertisement

Table of Contents
loading

Table of Contents