Installing The Power Interposer Board; System Battery; Replacing The System Battery - Dell PowerEdge R530 Owner's Manual

Installing the power interposer board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the cooling shroud.
NOTE: If applicable, close the expansion-card latch on the cooling shroud to release the full
length card.
4. If applicable, disconnect the power or data cables from expansion card (s).
5. If applicable, remove the expansion-card riser
Steps
1. Align the locking slots on the power interposer board with the hooks on the power supply cage and
slide it into place.
2. Route the power cables as applicable, and connect the power cables to the system board and hard
drive backplane.
3. Install the power supply module(s) in their original locations.
Next steps
1. If applicable, install the PCIe expansion-card riser.
2. If applicable, connect the required power or data cables to the expansion card(s).
3. Reinstall the cooling shroud.
4. If applicable open the expansion-card latch on the cooling shroud to secure the full length
expansion card.
5. Follow the procedure listed in
Related Links
Removing the cooling shroud
Removing the (optional) expansion-card riser
Installing the (optional) expansion-card riser
Installing the cooling shroud

System battery

Replacing the system battery

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the cooling shroud.
112
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.