DFI KS211 User Manual page 32

How to do your own work
If you are an operator in the factory, then all the knowledge you need is enough till now.
But, if you are a developer, you will probably have a couple of questions such as how to burn
my own image and default files, how to choose the dedicated storage device, etc.
The answer lies in a script: ucl.xml.
Manufacturing tool allows one to use the script to configure his/her own task list. Let's have an
overview of it. Open the file as shown below:
YourDiskVolume:\mfgtools-rel\Profiles\MX53 Linux Update\OS Firmware\ucl.xml
You can find that the script consists of one CFG section and a number of LIST sections. Never
change the CFG section which is used to guide some platform specific configurations to the
tool.
How to choose the dedicated storage device
You can see each LIST section which actually indicates one storage media type. Then how to
choose the one you need?
There are two ways to do this:
Method 1:
Open the file as shown below:
YourDiskVolume:\mfgtools-rel\Profiles\ MX53 Linux Update\player.ini
You will find the sentences as listed below:
[OS Firmware]
UCL_INSTALL_SECTION=NAND
The value "NAND" is one of the names in these LIST sections. Change it to your own choice.
Method 2:
You can also change the setting through the tool's GUI. Click the "Options" menu at upper-
right corner, and then further click the configuration item. A popup window as the following
picture on the right will appear.
Appendix A BSP User Guide
Appendix A
Left-click the Options item on the blue column, and then a popup window as shown below will
appear.
32
www.dfi .com