Yealink SIP-T46G User Manual page 152

User Guide for the SIP-T46G IP Phone
2. Press the Hold soft key to place the current multicast RTP session on hold.
3. Press the End Call soft key to cancel the multicast RTP session.
Note Multicast RTP is one way only from the sender to the multicast address(es) (receiver). For
outgoing RTP multicasts, all other existing calls on the phone will be placed on hold.
To send RTP stream via a paging key list:
1. Press the paging list key when the phone is idle.
2. Press
3. Press
4. Press the Hold soft key to place the current multicast RTP session on hold.
5. Press the End Call soft key to cancel the multicast RTP session.
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from
the pre-configured multicast address(es) without involving SIP signaling. You can
specify up to 10 multicast addresses that the phone listens to on the network.
How the phone handles incoming multicast paging calls depends on Paging Barge and
Paging Priority Active parameters configured via web user interface.
Paging Barge
The paging barge parameter defines the priority of the voice call in progress. If the
priority of an incoming multicast paging call is lower than that of the active call, it will be
ignored automatically. If Disabled is selected from the pull-down list of Paging Barge,
the voice call in progress will take precedence over all incoming multicast paging calls.
Valid values in the Paging Barge field:
1 to 10: Define the priority of the active call, 1 with the highest priority, 10 with the

lowest.
Disabled: The voice call in progress will take precedence over all incoming paging

calls.
140
or to select the desired group.
or the Paging soft key to send RTP .