SONIQ CWR300ND-AU Instruction Manual page 83

Field
Interface
Add Route
Update
Delete
Selected
Show
Routes
Static Route
Table
Click Show Routes, the page shown in the following figure appears. The table
shows a list of destination routes commonly accessed by your network.
3.6.2.2 RIP
Click RIP in the left pane, the page shown in the following figure appears. If you are
using this device as a RIP-enabled router to communicate with others using
Routing Information Protocol (RIP), enable RIP. This page is used to select the
interfaces on your devices that use RIP, and the version of the protocol used.
The interface for the specified route.
Click it to add the new static route to the Static Route
Table.
Select a row in the Static Route Table and modify the
parameters. Then click it to save the settings temporarily.
Select a row in the Static Route Table and click it to
delete the row.
Click it, the IP Route Table appears. You can view a list
of destination routes commonly accessed by your
network.
A list of the previously configured static IP routes.
Description
- 81 -