Access Control - SONIQ CWR300ND-AU Instruction Manual

The following describes the parameters of this page:
Field
Key Length
Key Format
Default Tx Key
Encryption Key 1
to 4
Apply Changes

3.4.3.3 Access Control

Choose WLAN > Access Control and the following page appears. In this page,
you can configure the access control of the wireless clients.
Choose the WEP key length. You can Choose
64-bit or 128-bit.
 If you choose 64-bit, you can choose ASCII (5
characters) or Hex (10 characters).
 If you choose 128-bit, you can choose ASCII
(13 characters) or Hex (26 characters).
Choose the index of WEP Key. You can choose Key
1, Key 2, Key 3, or Key 4.
The Encryption keys are used to encrypt the data.
Both the modem and wireless stations must use the
same encryption key for data transmission.
 If you choose 64-bit and ASCII (5 characters),
enter any 5 ASCII characters.
 If you choose 64-bit and Hex (10 characters),
enter any 10 hexadecimal characters.
 If you choose
characters), enter any 13 ASCII characters.
 If you choose 128-bit and Hex (26 characters),
enter any 26 hexadecimal characters.
Click it to apply the settings temporarily. If you want
to save the settings of this page permanently, click
Save in the lower left corner.
- 53 -
Description
128-bit and ASCII (13