SONIQ CWR300ND-AU Instruction Manual page 40

Field
Domain Name
DNS Servers
Set VendorClass
IP Range
Click Show Client in the DHCP Mode page, the page shown in the following figure
appears. You can view the IP address assigned to each DHCP client.
The following table describes the parameters and buttons in this page:
Field
IP Address
MAC Address
retains the assigned IP addresses before the IP
addresses change.
Enter the domain name if you know. If you leave this
blank, the domain name obtained by DHCP from the
ISP is used. You must enter host name (system
name) on each individual PC. The domain name can
be assigned from the router through the DHCP
server.
You can configure the DNS server ip addresses for
DNS Relay.
Click it, the Device IP Range Table page appears.
You can configure the IP address range based on the
device type.
Description
It displays the IP address assigned to the DHCP
client from the router.
It displays the MAC address of the DHCP client.
Each Ethernet device has a unique MAC address.
The MAC address is assigned at the factory and it
consists of six pairs of hexadecimal character, for
- 38 -
Description