SONIQ CWR300ND-AU Instruction Manual page 45

The following table describes the parameters of this page:
Field
Default Route Selection
VPI
VCI
Encapsulation
Channel Mode
Enable NAPT
Enabel IGMP
PPP Settings
User Name
Password
Type
Idle Time (min)
WAN IP Settings
Description
You can select Auto or Specified.
The virtual path between two points in an
ATM network, ranging from 0 to 255.
The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to
31 are reserved for known protocols)
You can choose LLC and VC-Mux.
You can choose 1483 Bridged, 1483 MER,
PPPoE, PPPoA, 1483 Routed or IPoA.
Select it to enable Network Address Port
Translation (NAPT) function. If you do not
select it and you want to access the Internet
normally, you must add a route on the uplink
equipment. Otherwise, the access to the
Internet fails. Normally, it is enabled.
You can enable or disable Internet Group
Management Protocol (IGMP) function.
Enter the correct user name for PPP dial-up,
which is provided by your ISP.
Enter the correct password for PPP dial-up,
which is provided by your ISP.
You can choose Continuous, Connect on
Demand, or Manual.
If set the type to Connect on Demand, you
need to enter the idle timeout time. Within the
preset minutes, if the router does not detect
the flow of the user continuously, the router
automatically disconnects
connection.
- 43 -
the PPPoE