Dhcp Static Ip - SONIQ CWR300ND-AU Instruction Manual

The following table describes the parameters and buttons of this page:
Field
DHCP Mode
Relay Server
Apply Changes
Reset

3.4.1.3 DHCP Static IP

Click DHCP Static IP in the left pane, the page shown in the following figure
appears. You can assign the IP addresses on the LAN to the specific individual
PCs based on their MAC address.
The following table describes the parameters and buttons of this page:
Field
IP Address
MAC Address
Add
If set to DHCP Relay, the router acts a surrogate
DHCP Server and relays the DHCP requests and
reponses between the remote server and the client.
Enter the DHCP server address provided by your ISP.
Click it to save the settings of this page.
Click it to refresh this page.
Enter the specified IP address in the IP pool
range, which is assigned to the host.
Enter the MAC address of a host on the LAN.
After entering the IP address and MAC address,
click it. A row will be added in the DHCP Static IP
- 41 -
Description
Description