SONIQ CWR300ND-AU Instruction Manual page 25

Field
WLAN
Interface
Band
SSID
Encryption
After finishing the configuration, click NEXT. The page shown in the following figure
appears.
You can choose Enable or Disable. By default, WAN
interface is enabled.
You need to enable WAN interface, and then you can
set the parameters in this page.
Choose the working mode of the router. You can choose
24 GHz(B), 24 GHz(G), 24 GHz(B+G), 24 GHz(N), 24
GHz(G+N) or 24 GHz(B+G+N).
The service set identification (SSID) is a unique name to
identify the router in the wireless LAN. Wireless stations
associating to the router must have the same SSID.
Enter a descriptive name that is used when the wireless
client connecting to the router.
Configure the wireless encryption mode. You can
choose None, WEP, WPA (TKIP), WPA (AES), WPA2
(AES), WPA2 (TKIP), or WPA2 Mixed.
 Wired equivalent privacy (WEP) encrypts data
frames before transmitting over the wireless
network.
 Wi-Fi protected access (WPA) is a subset of the
IEEE802.11i security specification draft.
 WPA2 Mixed is the collection of WPA and WPA2
encryption modes. The wireless client establishes
the connection between the router through WPA or
WPA2.
Key differences between WPA and WEP are user
authentication and improved data encryption.
Description
- 23 -