System Requirements - SONIQ CWR300ND-AU Instruction Manual

The following table describes the interfaces of the device:
Interface/Button
WPS/WLAN
ADSL
LAN4/3/2/1
Power
Reset

1.4 System Requirements

Recommended system requirements are as follows:
A 10/100 base-T Ethernet card is installed on your PC

A hub or Switch. (connected to several PCs through one of Ethernet

interfaces on the device)
Operating system: Windows 98SE, Windows 2000, Windows ME, Windows

XP
Internet Explorer V5.0 or higher, Netscape V4.0 or higher, or Firefox 1.5 or

higher
 Press the button silently less than 1s to enable
WLAN function.
 Press the button for more than 5s to enable WPS
function.
If you press the button between 1s and 5s, no function
takes effect.
RJ-11 interface, for connecting to the ADSL interface or
a splitter through a telephone cable.
RJ-45 interface, for connecting to the Ethernet interface
of a PC or the Ethernet device through an Ethernet
cable.
Power interface for connecting to the power adapter of
12 V DC ,1A.
Power switch, power on or off the device.
Reset to the factory defaults. To restore factory defaults,
keep the device powered on and insert a needle into the
hole for 3 to 6 seconds and then release.The device is
reset to the factory default configuration.
- 6 -
Description