Basic Default Configuration - GE Kilsen KFP-CF2 Installation Manual

Basic default configuration

Use this menu to select common operating mode configuration presets. The default
setting is 01 (EN 54-2, passive end-of-line).
To select an operating mode configuration preset:
1. Set the display as shown below, and then press Enter.
2. Select a value using the value selection buttons (2 and 4).
See Table 7 below for descriptions of the presets.
3. Press Enter.
4. Save your changes.
A selected list of operating mode configuration presets is shown below. For a detailed
list of all available configuration presets and characteristics, see Appendix A
"Configuration presets" on page 59.
Table 7: Common operating mode configuration presets
Display Operating mode
01 (default) EN 54-2
05 EN 54-2 Evacuation
07 EN 54-2 Scandinavia
11 BS 5839-1
21 NBN S21-100
31 NEN 2535
The operating mode is indicated by the first digit in the display and the configuration
type by the second digit. If a custom configuration has been applied (via the
advanced configuration menu), then the second digit is a zero, as shown below.
Display Configuration
01 EN 54-2 preset configuration
11 BS 5839-1 preset configuration
21 NBN S21-100 preset configuration
31 NEN 2535 preset configuration
Kilsen KFP-CF Series Installation Manual
Chapter 3: Configuration and commissioning
Zone end-of-line Zone type
Passive Mixed
Passive Mixed
Passive Mixed
Active Mixed
Passive Automatic
Passive Odd zones: Automatic
Even zones: Manual
Display Configuration
00 EN 54-2 custom configuration
10 BS 5839-1 custom configuration
20 NBN S21-100 custom configuration
30 NEN 2535 custom configuration
25