Checking Names Of Saved Performance Data (Name) - Roland VS-1680 Owner's Manual

Checking Names of Saved
Performance Data (Name)
This operation lets you check the names of song data
that was saved to a DAT tape. Even if you have saved
the data of two or more songs in a single backup oper-
ation, you can check the name of each song.
This operation also allows you to load selected song
data into the VS-1680. When the recover operation is
used, the data for all songs which were saved together
by the backup operation are loaded. In contrast, with
the Name procedure, only the song data that you spec-
ify is loaded.
1. Connect the DAT recorder to the VS-1680 as fol-
lowing.
fig.09-06c(dat_rc_connect)
Optical
DAT recorder
fig.09-06d(dat_rc_connect)
Digtal Out
Chapter 9 Use with a DAT Recorder (DAT Backup)
Coaxial
2. Insert the tape which contains the song data into
the DAT recorder. If the song data is backed up
on two or more tapes, insert the first tape.
3. Prepare the tape for playback from the beginning
of the song data.
4. Hold down [SHIFT] and press [F6 (UTILITY)].
The Utility menu icon appears in the display.
5. Press [F1 (DATRc)]. If "DATRc" does not appear
in [F1], first press [PAGE] until "DATRc" is dis-
played, then press [F1 (DATRc)].
6. Press [
] to move the cursor to "Digital In
Select" and rotate the TIME/VALUE dial.
Digital In Select
Select either "DIGIN1" (coaxial) or "DIGIN2" (optical)
if you are going to recover data using the VS-1680's
DIGITAL IN connector.
7. Press [F1 (Name)].
"Please Play DAT" appears in the display.
8. Put the DAT recorder in play mode.
This executes the loading of the song name.
Digital Out
DAT recorder
145