Roland VS-1680 Owner's Manual page 73

12. Press [PAGE] until "Pan" is displayed in [F1], then press [F1 (Pan)].
fig.03-31(pan.eps)
13. Press [
(Master Send Switch)
When this is set to "On," the source from each input channel, rather than being
assigned to the recording bus, is sent directly to the MIX bus. Set this to "On"
when, for example, you simply want to mix the inputs without recording them.
However, the sources that are assigned to the RECORDING bus are disabled.
(Master Send Pan)
This adjusts the pan setting (L63–0–R63) of the signal sent to the MIX bus and
the RECORDING bus. For now select "R63."
14. Press the Input Channel 7 SELECT button.
15. Repeat the Steps 9–13 to make the settings for Input Channel 7 as same as
16. Now the setup is completed. In this case, the signal flow will be as the fol-
fig.03-32(insrec.eps)
Master Send Switch
Master Send Pan
] and [ ] to move the cursor. With the TIME/VALUE dial, set
the Switch and Pan settings for Input Channel 8.
those for Input Channel 8. However, select "InsL" and "L63" for Steps 11
and 13, respectively.
lows.
EQ Snd
(2band, 3band) Level
Input Channel 7
Input Channel 8
EQ Snd
(2band, 3band) Level
STATUS
TRACK
9-1
9-2
9-3
9-4
9-5
9-6
9-7
9-8
9-9
9-10
9-11
9-12
9-13
9-14
9-15
9-16
Chapter 3 Multi-Track Recording
Level
Rtn
Level (Fader)
(InsL)
EFX1
(InsR)
Rtn Level
Level (Fader)
REC bus
EQ Level
(2band, 3band) (Fader)
Track Channel 9/10
Pan
Pan
MIX bus
MASTER OUT
Pan
73