Roland VS-1680 Owner's Manual page 147

Coaxial
DAT recorder
fig.09-07b(dat_rc_connect)
Coaxial
DAT recorder
Chapter 9 Use with a DAT Recorder (DAT Backup)
Digital Out
Digital Out
1. Connect the DAT recorder to the VS-1680 as left.
2. Insert the tape which contains the song data into
the DAT recorder. If the song data is backed up
on two or more tapes, insert the first tape.
3. Prepare the tape for playback from the beginning
of the song data.
4. Hold down [SHIFT] and press [F6 (UTILITY)].
The Utility menu icon appears in the display.
5. Press [F1 (DATRc)]. If "DATRc" does not appear
in [F1], first press [PAGE] until "DATRc" is dis-
played, then press [F1 (DATRc)].
6. Press [
] to move the cursor to "Digital In
Select" and rotate the TIME/VALUE dial.
Digital In Select
Select either "DIGIN1" (coaxial) or "DIGIN2" (optical)
if you are going to recover data using the VS-1680's
DIGITAL IN connector.
7. Press [F2 (Verify)].
"Please Play DAT" appears in the display.
8. Put the DAT recorder in play mode.
Verify the tape. If you have backed up the data to mul-
tiple tapes, then the operation is suspended when the
end of each tape is reached. Insert the number tape
indicated in the display, press [YES], and start the
DAT recorder playing again.
9. When loading is finished, "Please Stop DAT"
appears in the display. Stop the DAT recorder,
then press [YES].
10. If there is no problem with the condition of the
recorded song data, "Complete" appears in the
display. If a warning message appears when the
song data is loaded, then that song data cannot be
loaded correctly. If you wish to check a tape
again, insert the number tape indicated in the dis-
play, press [YES], and start the DAT recorder
playing again. Press [NO] if you want to finish the
procedure without checking the tape again.
* To cancel this operation, press [EXIT (NO)].
147