Master Fader - Roland VS-1680 Owner's Manual

4. SELECT/CH EDIT
(Select/Channel Edit) buttons
Use these buttons when you wish to change track
mixer settings and to change track channels. The cur-
rently selected channel's indicators are lit.
1–15/16: Each channel (1–15/16)
When you press these buttons while holding down the
STATUS button, you can select a particular track to re-
recorded to (Track Bouncing).
When numerics are combined with alphabetical char-
acters ([NUMERIC/ASCII]), alphabetical characters
can be input directly (Song Name, etc.).
5. STATUS Buttons
These buttons switch the status of each track. The cur-
rent status is shown by the button indicator.
SOURCE (orange):
The input source or track assigned to the channel is
being output.
REC (blinking red):
Recording is selected for the track assigned to the
channel. During playback, the track data is nor-
mally output.
REC (blinking red and orange):
Recording is selected for the track assigned to the
channel. During playback, you will be able to lis-
ten to the track.
PLAY (green):
The track assigned to the channel will playback.
OFF (off):
The channel is muted (silent).
When pressed in combination with the SELECT/CH
EDIT button, this selects the source or track to be
assigned to a track for recording.
6. Channel Faders
Use these faders to adjust the volume level of each
channel or track.
7. MONITOR Knob
This adjusts the volume level output from the MONI-
TOR jacks.
8. PHONES Knob
This knob adjusts the volume of the headphones.
9. AUTOMIX Button
This button switches the Auto Mix function on and off.
The button indicator lights when Auto Mix is on.
10. EZ ROUTING Button
This button opens the EZ Routing screen.
11. EDIT/SOLO button
Press this button to make block settings for the master
section of the mixer.
To use the Solo function to monitor only a specific
channel, press this button while holding down the
SELECT/CH EDIT button.
12. FADER/MUTE Button
Pressing this button alternately assigns each channel's
input mixer and track mixer to the fader for that chan-
nel. The button indicator shows the current status.
To mute the channel, press this button while holding
down the SELECT/CH EDIT button.

13. Master Fader

Use this fader to adjust the overall output level.
Front and Rear Panels
15