Part Names; Turning On The Power - Roland MT-120s Owner's Manual

Part Names
Front Panel
See page 5 of the
MT-120 Owner's
Manual for these
descriptions.
Left Speaker
Reproduces
the left chan-
nel sounds.
Right Speaker
Reproduces the
right channel
sounds.
Headphone Jack
This is the jack to
use for plugging in
headphones.
The speakers are
cut off when head-
phones are plugged
in, making it great
for playing at night
or when other peo-
ple are around.
Power Switch
This turns the
power to the MT-
1205 on and off.
Rear Panel
See page 4 of the
MT-120 Owner's
Manual for these
descriptions.
* The Output L jack
on the MT-120S
cannnot be used
for Mono output.
in
power cord that
comes with the
MT-120S, then
* Make sure that
the Piano switch
on the back of the
MT-120S is set to
"int"
Turning On the Power
(1) Connect the AC cord that came with the unit into the MT-120S,
then plug the other end into an AC socket.
(2) Turn down the volume to its lowest level (all the way to the left).
(3) Turn on the power switch.
* This unit is equipped with a protection circuit. A brief interval (a few seconds)
afler power up is required before the unil will operate normally.