Roland VS-1680 Owner's Manual page 122

Chapter 7 Use with a CD-R Drive
10. This display appears as shown below. Check each
of the capacity. At this time, if you move the cur-
sor to "L-ch Source Track" or "R-ch Source
Track," you can switch each of the by rotating the
TIME/VALUE dial.
fig.07-06(capa.eps)
Track which you want written as the right track
Track which you want written as the left track
Song Name
Internal IDE hard disk free space
Disk space occupied by a song when written to a CD-R disc
Length of the song which is to be written to the CD-R disc
Number of tracks after writing to the disc is finished
Number of Markers used for track numbers
Determining whether or not the CD-R disc has data written to it
* If the "space required for the song being written to the
CD-R disc" exceeds the total of the "free space on the
internal IDE hard disk" and the "free space on the CD-R
disc," you cannot write the song to the CD-R disc.
Disk space required for the song being
written to the CD-R disc
The disk space occupied by a song when written
to a CD-R disc may not be equivalent to the size
of the song itself. This is something that varies
with the number of tracks and recording mode
used. You can make a rough estimate of the space
required for a song when written to a CD-R disc
as shown below.
Size (bytes) = 44,100 (Hz) x 2 (stereo tracks) x 2
(bytes) x "song length" (in seconds)
* The used capacity of the song is displayed as 1 MB =
1,000,000 bytes. The displayed value is the approximate
standard value.
11. Press [
], [ ], [
cursor to "Finalize," and rotate the TIME/VALUE
dial.
122
CD-R disc free space
Size of the content written to the CD-R disc
], and [ ] to move the
Finalize
To make CD-R discs prepared with the VS-1680
playable on ordinary CD players, a TOC (Table of
Contents) must be written. Nothing beyond this can be
written to finalized CD-R discs.
TOC (Appendices p. 65)
Off: The song is written without the finalize proce-
dure being carried out.
After the song is written, the finalize proce-
On:
dure is performed.
OnlyFin.: Only the finalize procedure is carried out,
without the song being written.
12. Press [F4 (Exec)].
A confirmation message appears in the display.
13. Press [YES].
A message with the licensing conditions appears in
the display. After reading this carefully, if you agree to
the conditions, press [YES].
This message also appears in the back cover of this
manual. Writing to the CD-R disc begins. If you do not
agree to the terms, press [NO]. Return to the Step 2.
If "Not 44.1k Song!" Appears in the
Display
The sample rate is not 44.1 kHz, so the song can-
not be written to the CD-R disc. Press [ENTER
(YES)] to return to Step 1. Please refer to
"Creating a New Song" (p. 58).
If "Please Insert Disc!" Appears in the
Display
This indicates that the CD-R drive's loading tray
is open, that there is no disc loaded, or that the
CD-R drive is in some other way not ready for
use. Insert a CD-R disc, and press [YES].
14. After writing of the CD-R disc is correctly per-
formed, "Write Another?" appears in the display.
If you wish to write the same song data to another
CD-R disc, place a new disc in the drive and press
[YES]. Press [NO] to return to the Step 2.